
The gate shouldn’t be built after the fence has been constructed. The design and construction of the security gate must be complimentary to the construction of the fence. Before installing the security gate, there are specific tools which is needed. Framing and combination squares, drill-drivers, wrenches, slip-joint pliers, screwdriver bits. Hinges, shims, latches, galvanized and lag screws are essential.
The hardest part of installing a protection gate, is to put it correctly in the opening, before any hardware is attached. The simplest way to do this, is always to prop up the gate on some scrap boards, until it roughly fits the opening. Some final adjustments may be made, by inserting some shims involving the boards, and the bottom and sides of the gate. You can also clamp the boards to the fence to help keep it from moving before hardware is installed.
• The framing square can be utilized to point if the gate is correctly positioned. If it is out of square, a diagonal measurement will show which corner is longer. A clamp can be utilized to tighten the gate until it is square, and Thunder Protection system in Bangladesh you need to use a brace for reinforcement, before marking the place for placement of the hinges.
• Prop the gate in the opening, until it is aligned correctly, before attaching the hinges based on the manufacturer’s instructions. Check the alignment on both sides with the shims. You should allow some clearance for sagging, by sliding a shingle under the lower side. Visually inspect the proposed position from both leading and back sides of the gate.








